Mjk-automation Shuttle Ultrasonic Level Transmitter and Sensor Uživatelský manuál stáhnout pdf (Strana 57)

SW 838023

GB Shuttle Manual 100316

Appendix

Select factory settings

All settings - except calibration of the level measurement

- made after initial startup will be reset to factory settings

with this function.

The zero point setting will also be adjusted to the immediate

level in the well / tank. Furthermore, the mA output is set to

4 mA at the current zero point and 20 mA at a level corres-

ponding to a distance of 14 in from the ultrasonic sensor.

Note: The function will cause Shuttle

to start up the

same way it did when the supply power was

turned on for the ﬁrst time..

... after which Shuttle

returns to normal read-out.

Select 'ON' with the arrow keys.

This is shown in the display until Shuttle

detects a valid

echo again.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 69 70

Žádné komentáře

Mjk-automation Shuttle Ultrasonic Level Transmitter and Sensor Uživatelský manuál Strana 57